Car stereo self installing

Sounds like it would do, although you might want to google a little further to see if other people have this problem with hyundais. It depends on where the amp in the stock setup is. In my volvo's case, the amp wasn't in the radio.

Most aftermarket radios have a small amp in them and include preamp outs so you can set it up with your own amps. You may just want to go that route and not worry about what's already in the car. Any unaccounted for wires? Any of them red or black? What I mean by unaccounted is that there may be wires that went into the radio that you're not wiring to that are tied to an amp somewhere in the car. By not using them, you're getting no amplification.

An alternative answer to this question would be that I bought the wrong wiring harness. Read smile. Add a comment. Thank you for you interest, and I did isolate each one. There didn't seem to be a difference in sounds. I double checked each wire once before, but I will triple check.

OK, thanks, I agree that it sounds like you have a different issue. Just to be clear, if the speakers aren't polarized correctly, each individual speaker will sound fine. It is only when you add in a second, reverse-polarized speaker that the sound would start to degrade Not Helpful 0 Helpful 1. No, but it doesn't hurt as a good safety precaution to prevent electric shock. Not Helpful 0 Helpful 0. Very often, yes. Retailer sites like Crutchfield and Amazon will show you what's needed to connect a radio you bought there to different makes and models of car.

They're usually not strictly necessary but can simplify the installation. Include your email address to get a message when this question is answered. If you need help deciding what to buy, go to an electronics store or a store specializing in auto electronics and ask for assistance choosing a stereo. If a stereo does not fit there are may be an aftermarket kits available to make it fit.

For more information, go here. Helpful 0 Not Helpful 0. Some retailers may offer to install your stereo for free or minimal cost if you buy it from them, so be sure to inquire. When removing any screws or nuts, place them in the car's cup holder so they don't get lost. Helpful 1 Not Helpful 0. To make joining the wires easier, see if there is an adapter that connects your old harness to the new stereo.

Follow the specific instructions provided with the new stereo. Some of the installation steps may be specific to your car and stereo. Helpful 13 Not Helpful 4. If you find yourself feeling lost or frustrated, get help from a professional — otherwise you may damage the car or hurt yourself.

Helpful 7 Not Helpful 4. You Might Also Like How to. How to. Co-authors: Updated: April 8, Categories: Car Radios and Sound Systems. Italiano: Installare uno Stereo per Auto. Deutsch: Ein Autoradio einbauen. Bahasa Indonesia: Memasang Audio Mobil. Nederlands: Een autoradio installeren. Thanks to all authors for creating a page that has been read 1,, times. Reader Success Stories Timmi Nov 22, More reader stories Hide reader stories.

Is this article up to date? Cookies make wikiHow better. By continuing to use our site, you agree to our cookie policy. About This Article. Timmi Nov 22, Leona Becerra Apr 8, Share yours! More success stories Hide success stories. Featured Articles How to. Trending Articles How to.

This necessitates installing a new wire harness, which consists of a succession of wires secured in rope-like shapes. This makes it simpler to get to it afterwards and to keep everything neat and organized.

Unfortunately, the wire harness is expensive on its own, and putting it together takes time. It will also cost more to have it installed. The second is, without a doubt, the best option. If you buy a CD player from a service station, some will give you a discount or even waive the installation price.

Because this can take hours if not longer , full-overhaul installations will almost certainly add several hundred dollars to the bill. It all boils down to the system you want to learn about. What is needed for self-installation? How much does it cost to self-install a radio? You may need to spend money on the essential hardware screws and wires. However, keep in mind that doing it yourself may end up being more expensive in the long run. A Single-DIN radio, for example, is 2 inches high by 8 inches long.

It is the smaller of the two and the more common in tiny automobiles. Slide the new stereo into the dash. This step will differ with each car and may require first sliding in a DIN cage, or simply mounting the aftermarket stereo onto the original mounting brackets.

Test the aftermarket stereo. Make sure no wires have become disconnected or pinched. Reconnect the negative battery terminal and power up your vehicle. Make sure that all features of the radio and all the speakers are working. Troubleshoot the stereo installation. If it doesn't work, you likely have a loose connection or have joined the wires incorrectly.

Disconnect the negative battery terminal and troubleshoot. Make sure that the original wiring harness and aftermarket wiring harness adapter are securely attached. Make sure that all of the connections between the aftermarket wiring harness adapter and the aftermarket stereo plug are correct. Double check with the manual that came with the aftermarket stereo or adapter. Ensure that the aftermarket stereo plug is properly and tightly plugged into the back of the aftermarket stereo.

Part 4. Re-assemble the dash. Once the new stereo works, secure it into the dash and put everything back together. This is the same way that dash was disassembled, but in reverse.

Reconnect the negative battery terminal. If you unplugged the terminal again after testing the battery, you can reconnect it now. Enjoy your new stereo! Your installation is complete and you can show off your new aftermarket stereo. Look for a wiring diagram for your car as well as the wiring diagram for the head unit. This will guide you in relation to the exact model you're using.

Yes No. Not Helpful 1 Helpful Do I need to connect the RCA cable and wiring harness that came with my new aftermarket stereo? If so, where do I connect it? The RCA cables are for if you have an amp. If you are not hooking up subwoofers you don't need the RCA. If you are, the RCA runs to your amp. Not Helpful 1 Helpful 2. You may be able to get an adapter plate for your make and model from a car radio specialist, and possibly a wiring adapter identity, if need be.

Not Helpful 2 Helpful 2. Black -- any negative earth. Not Helpful 3 Helpful 4.