Real time windows target simulink

The block 'heavy calculation' is too slow to be calculated in 0. Does this work? Thank you very much! Best Answer. The "scheduling" chapter of he Simulink Coder documentation will explain you how to control ow the execution of a slow task can be spread over multiple steps of a fast rate:.

It would be great if you can help me. Many, many thanks for your information. Jan Houska on 15 Aug You will get a dialog allowing you to set baud rate etc. You can then just select the installed board in all other blocks that need to use the same port with the same parameters.

Ah, ok. The configuration of the Serial Port isn't difficult. The composition is so that I am testing with two PCs. There are XBee-modules connected at both PCs. So I can transmit and receive data. It is only for testing purposes. But I don't know how I can do it.

How is the configuration? I think, that I have to use the Stream Output block for this test. What should I do with the input of the Stream Output block? I can't connect the input with a constant block, or is it wrong? When I understand that all, then I can programm the real important thing.

It is so, that I must receive formatted data like this string: 1. The regulated result is than an double too. This result have to transmitted to the other XBee-module. Sorry for my English, it isn't best. More Answers 1. Jan Houska on 14 Aug Vote 1. You cannot use Windows functions in real-time code. You should never include windows. Naveen on 20 Jul When I try to send 7 bytes as a packet through Packet output block sample rate 0.

The same thing when done for odd bytes with an increased sample time 1 sec and keeping the baud rate the same, some bytes are missing on the terminal. Jason Chen on 21 Jul I think there is a buffer in the UART chip used for serial communication.

The buffer might overflow when you try to send too many bytes. Try to break up the message into several groups and wait a while between each group. While the kernel is idle, the operating system controls the execution of standard applications, such as Internet browsers, word processors, and the MATLAB environment.

The kernel becomes active when you begin execution of your model, and becomes idle again after model execution completes.

If you encounter problems with Simulink Desktop Real-Time software, you can uninstall the kernel. Once uninstalled, the kernel is no longer active. The kernel executable file remains on your hard drive so that you can later reinstall it.

Type y to continue uninstalling the kernel, or n to stop uninstalling without changing the installation. After uninstalling the kernel, check that it was uninstalled. If you uninstalled the MATLAB environment without uninstalling the kernel, open a development computer command window and type:. The sldrtkernel program uninstalls the kernel by removing it from memory, then displays the message:. Choose a web site to get translated content where available and see local events and offers.

Based on your location, we recommend that you select:. Select the China site in Chinese or English for best site performance. Other MathWorks country sites are not optimized for visits from your location. Get trial now.

Toggle Main Navigation.